1.5A Step-Up Current Regulator for Flash LEDs

Manufacturer's part number :

AAT1271AIWO-T1

NATO number :

AAT1271

Manufacturer Skyworks

Skyworks

Description :

The AAT1271A is a high-efficiency, high-current boost converter capable of 1.5A typical output current. It is an ideal power solution for LED photo flash applications in all single cell Li-ion powered products. The AAT1271A maintains output current regulation by switching the internal high-side and low-side switch transistors. The transistor switches are pulse-width modulated at a fixed frequency of 2MHz. The high switching frequency allows the use of a small inductor and output capacitor, making the AAT1271A ideally suited for small battery-powered applications. AnalogicTech's proprietary AS2Cwire™ (Advanced Simple Serial Control™) serial digital interface is used to enable, disable, configure, and program the operation of the AAT1271A. Using the AS2Cwire interface, the movie mode current level for each LED, the safety timer delay, and the flash-to-movie-mode current ratio can be programmed to one of 16 levels. In addition, the single-wire serial protocol sets output channel control. The AAT1271A also includes a separate Flash Enable input to initiate both the flash operation and the default timer which can be used either to terminate a flash event at the end of a user-programmed delay or as a safety feature. Also included is a Flash Inhibit pin which reduces the flash current to movie-mode levels during high battery demand. The maximum flash and movie-mode current is set by one external resistor where the ratio of Flash to Movie mode current is set at approximately 7.3:1. One or two LEDs can be connected to the AAT12 71A, where in the case of two LEDs the output current is matched between each diode. The AAT1271A contains a thermal management system to protect the device in the event of an output short circuit condition. Built-in circuitry prevents excessive inrush current during start-up. The shutdown feature reduces quiescent current to less than 1.0μA. The AAT1271A is available in a Pb-free, thermally enhanced 14-pin 3x3mm TDFN package.

View our wide range of Analogue / Mixed signal products

View our portfolio of Semiconductors

See all products from our supplier Skyworks

RoHS

RoHS

  • Quote and availability

    Features

    • VIN Range: 2.7V to 5.5V
    • Dual Channel Output
    • Up to 1.5A Regulated Output Current (750mA per channel)
    • Up to 85% Efficiency with Small Inductor (1μH)
    • 2 MHz Switching Frequency
    • Separate Flash Enable
    • Separate Flash Inhibit
    • User-Programmable Safety Timer
    • Single Resistor Sets Flash and Movie Mode Current
    • AS2Cwire Single Wire Programming:
    • Movie Mode Current
    • Flash/Movie Mode Current Ratio
    • Movie Mode Output Configuration
    • Flash Safety Timer
    • True Load Disconnect
    • Input Current Limit
    • Over-Voltage (Open LED, Open Circuit), Short Circuit, and Over-Temperature Protection
    • Shutdown Current < 1.0μA
    • 14-pin TDFN 3x3 mm Package
    • -40°C to +85°C Temperature Range

    How wireless works

Features Similar products
Control scheme Advanced Simple Serial Control  

  similar products found

Search similar products
Switching frequency (kHz) 2000  
Max Input Voltage (V) 2.7 to 5.5  
Output Voltage (V) 5.5  
Typ. Active Current (µA) 670  
Output Capacitor Type 2.2 μF, Ceramic Capacitor  
Output Current (mA) 1500  
Operating Temperature (°C) -40 to +85  
Package TDFN33-14